Source - Argus Tracking Information Sheet
Follow the simple steps:
- Turn on the ignition
Wait 10 - 30 seconds for the system to power up.
- Wait for the system to beep
Once you hear it, place your driver ID card directly on the RFID reader for 5 - 10 seconds
- Confirm your ID is recorded
The beeping will stop once your ID has been successfully logged. You are good to go!
Tips:
Only scan your ID after the ignition is on. Scanning before this won't record your ID.
Make sure the card is flat and fully touching the reader.
The RFID reader is a small, black, button-like circle typically located on the dashboard - either to the right of the steering wheel, in the center, or near the top.
For any issue, please contact support@argustracking.com